Ysi 556 MPS Bedienungsanleitung PDF herunterladen (Seite 120)

YSI Incorporated YSI 556 MPS

Page 114

19. Appendix F Ferrite Bead Installation

WARNING: If you are using your YSI 556 in a European Community (CE)

country or in Australia or New Zealand, you must attach a ferrite bead to the

655173 PC Interface Cable and the YSI 6117 Charger Adapter Cable in

order to comply with the Residential, Commercial and Light Industrial Class

B Limits for radio-frequency emissions specified in EN55011 (CISPR11)

for Industrial, Scientific and Medical laboratory equipment. These ferrite

assemblies are supplied as part of cable kits.

1. Make a small loop (approximately 5 cm in diameter) in the

cable near the YSI 556 MS-19 connector.

2. Lay the open ferrite bead assembly under the loop with the

cable cross-over position within the cylinder of the ferrite

bead.

Figure 19.1 Ferrite Bead Installation

3. Snap the two pieces of the bead together making certain that

the tabs lock securely.

4. When the installation is complete, the 655173 and 6117

cables should resemble the following drawings.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 135 136

Keine Kommentare

Ysi 556 MPS Bedienungsanleitung Seite 120